Rosewill R2-RAID Manuel d'utilisateur télécharger pdf (Page 10)

Server RAID System [ R2-RAID ] User Manua

Jumper Selection & Storage Policy Definitions

GUI MODE (factory default)：This mode allows you to use the SteelVine

Manager GUI to configure the storage policy and other settings as well as

monitor the status of the appliance (i.e., storage capacity, and RAID mode

of the desired hard drive). To select this mode the first time that the

product is used, ensure that the hard disk drives are installed, set

switching jumper on the back of the device to the GUI position and turn on

the power. In this mode, no virtual volume(s) will be created until the

storage policy and volume selections are made through the GUI. To

change from GUI mode to some other fixed storage policy thereafter, set

the switching jumper to the desired position and press the reset button to

create the new virtual volume(s).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Pas de commentaire

Rosewill R2-RAID Manuel d'utilisateur Page 10