Rosewill RCW618 Manuel d'utilisateur télécharger pdf (Page 10)

User Manual

SATA/IDE to Detachable USB 2.0 Adapter(Support 2.5", 3.5" & 5.25" IDE/SATA Drive) RCW618

Trouble shooting

i. Q: I completed the installation by following the menu but MS Windows can’t detect any

hard drive.

A: The reason of the problems could be:

1. Hard drive has not completed the format or F-disk process.

* Solution: Format or F-disk your hard drive.

2. The hard drive failed.

* Solution: Replace a workable hard drive.

3. Bad USB connection.

*Solution: Unplug the USB connection and re-connect the USB again.

4. Check LED light on the adapter. If the red LED light on RCW-618 is not on after

connected with PC, this adapter is not working correctly.

*Solution: Please contact our RMA department for replacement.

ii. Q: After I installed RCW-618 to the hard drive, my hard drive will not run.

A: Four pin power connector is directional. If you plug in the four pin power connector in

reverse, your hard drive might be damaged.

*Solution: Please make sure the direction of 4 pin power connector is correct before you

plug it to your hard drive. The shape of the male 4 pin connector must ﬁt the female

connector of your hard drive as pictures shown below.

iii. Q: Fail or slow system boot up when RCW-618 was connected with PC.

A: This issue is caused by the hardware conﬂiction of the system scanning during boot

up.

*Solution:Please disconnect RCW-618 from your PC before system boot up.

Connect it to PC after the Windows complete boot up.

Thank you for purchasing a quality Rosewill Product.

Please register your product at : www.rosewill.com/

for complete warranty information and future support for your product.

If you have any question while using our products, please feel free to contact us at [email protected].

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Rosewill RCW618 Manuel d'utilisateur Page 10